CONNER PERIPHERALS, INC. ======================== AT ADAPTER BOARD +------------------------------------------------------------+ +------------------------------------------------------------+ Data bus: 16-bit, ISA Size: Half-length, full-height card Hard drives supported: Two IDE Interface (AT) drives Floppy drives supported: None +------------------------------------------------------------+ | CONNECTIONS | |------------------------------------------------------------| | Function | Location | |----------------------------------------------+-------------| | 40-pin IDE Interface (AT) connector-internal | CN1 | +------------------------------------------------------------+ +------------------------------------------------------------+ | USER CONFIGURABLE SETTINGS | |------------------------------------------------------------| | Function | Location | Setting | |------------------------------------+----------+------------| |>> | Hard drive port address is | JP1 | open | | | 1F0-1F7h | | | |---+--------------------------------+----------+------------| | | Hard drive port address is | JP1 | closed | | | 170-177h | | | |---+--------------------------------+----------+------------| |>> | Chip Select 1 (CS1) enabled | JP2 | closed | |---+--------------------------------+----------+------------| | | Chip Select 1 (CS1) disabled | JP2 | open | |---+--------------------------------+----------+------------| |>> | IRQ14 is cleared with a status | JP3 | pins 2 & 3 | | | read only | | closed | |---+--------------------------------+----------+------------| | | IRQ14 is cleared with | JP3 | pins 1 & 2 | | | deassertion of Host Slv/Act | | closed | +------------------------------------------------------------+