DATA TECHNOLOGY CORPORATION =========================== DTC2132D +------------------------------------------------------------+ |------------------------------------------------------------| | Data bus: | 32-bit PCI | |--------------------+---------------------------------------| | Size: | Half-length, half-height card | |--------------------+---------------------------------------| | Hard drive | Four IDE(AT) or EIDE interface drives | | supported: | | |--------------------+---------------------------------------| | Floppy drives | None | | supported: | | +------------------------------------------------------------+ +------------------------------------------------------------+ | CONNECTIONS | |------------------------------------------------------------| | Function | Location | |--------------------------------------------+---------------| | 10-pin DTC-1415 ISA B Interrupt adapter | J1 | | connector | | |--------------------------------------------+---------------| | 4-pin connector - drive active LED | J2 | |--------------------------------------------+---------------| | 40-pin connector - primary IDE(AT) | J3 | | interface | | |--------------------------------------------+---------------| | 40-pin connector - secondary IDE(AT) | J4 | | interface | | |------------------------------------------------------------| | Note: Connector J1 is intended for use in systems that do | | not support redirected PCI interrupts. | +------------------------------------------------------------+ +------------------------------------------------------------+ | USER CONFIGURABLE SETTINGS | |------------------------------------------------------------| | Function | Location | Setting | |------------------------------------+-------------+---------| |>> | Primary port INTA redirect to | W1/pins 1 & | closed | | | IRQ14 | 3 | | |---+--------------------------------+-------------+---------| | | Primary port INTB redirect to | W1/pins 2 & | closed | | | IRQ14 | 4 | | |---+--------------------------------+-------------+---------| | | Primary port INTC redirect to | W1/pins 3 & | closed | | | IRQ14 | 5 | | |---+--------------------------------+-------------+---------| | | Primary port INTD redirect to | W1/pins 4 & | closed | | | IRQ14 | 6 | | |---+--------------------------------+-------------+---------| | | Secondary port INTA redirect | W2/pins 1 & | closed | | | to IRQ15, IRQ12 or IRQ11 | 3 | | |---+--------------------------------+-------------+---------| | | Secondary port INTB redirect | W2/pins 2 & | closed | | | to IRQ15, IRQ12 or IRQ11 | 4 | | |---+--------------------------------+-------------+---------| | | Secondary port INTC redirect | W2/pins 3 & | closed | | | to IRQ15, IRQ12 or IRQ11 | 5 | | |---+--------------------------------+-------------+---------| | | Secondary port INTD redirect | W2/pins 4 & | closed | | | to IRQ15, IRQ12 or IRQ11 | 6 | | |---+--------------------------------+-------------+---------| |>> | Fixed IDE address at power-up | W3 | closed | | | (1F0-1F7h) | | | |---+--------------------------------+-------------+---------| | | Relocatable IDE address at | W3 | open | | | power-up | | | |---+--------------------------------+-------------+---------| |>> | IDE decode state disabled | W4 | closed | | | after reset | | | |---+--------------------------------+-------------+---------| | | IDE decode state enabled after | W4 | open | | | reset | | | +------------------------------------------------------------+