KOUWELL ELECTRONICS CORPORATION
===============================

   KW-801

   Data Bus                32-bit PCI                             
   Card Size               Half-height, half-length card          
   Hard Drives supported   Up to 7 SCSI-2 devices                 
   Floppy drives supported None                                   

<gopher://bitreich.org/I/th99/c/I-L/21404-1.png>
   

   +------------------------------------------------------------+
   |                        CONNECTIONS                         |
   |------------------------------------------------------------|
   |  Function   | Location |        Function        | Location |
   |-------------+----------+------------------------+----------|
   | 50-pin SCSI |    J1    | 2-pin connector -      |    J4    |
   | connector - |          | drive active LED       |          |
   | internal    |          |                        |          |
   |-------------+----------+------------------------+----------|
   | 50-pin SCSI |    J2    |                        |          |
   | connector - |          |                        |          |
   | external    |          |                        |          |
   +------------------------------------------------------------+

   +------------------------------------------------------------+
   |                USER CONFIGURABLE SETTINGS                  |
   |------------------------------------------------------------|
   |               Function               | Label  |  Position  |
   |--------------------------------------+--------+------------|
   |>>   | Active termination enabled     |  JP1   |   Closed   |
   |-----+--------------------------------+--------+------------|
   |     | Active termination disabled    |  JP1   |    Open    |
   |------------------------------------------------------------|
   |      Note: When BOTH external AND internal devices exist,  |
   |      disable on-board termination jumper JP1 and insert    |
   |      the resister array RP1-RP3. This setting is used if   |
   |      controller lies within the device chain. When only    |
   |      external devices OR only internal devices exist,      |
   |      enable JP1 and remove resister arry RP1-RP3. This     |
   |      setting is used when controller is at one end of      |
   |      device chain. (Location of resistors RP1-RP3 is       |
   |      unidentified.)                                        |
   +------------------------------------------------------------+

   +------------------------------------------------------------+
   |                  PCI INTERRUPT SELECTION                   |
   |------------------------------------------------------------|
   |     Setting      |        JP2         |        JP3         |
   |------------------+--------------------+--------------------|
   |>> |     INTA     | Pins 2 & 3 closed  |        Open        |
   |---+--------------+--------------------+--------------------|
   |   |     INTB     | Pins 1 & 2 closed  |        Open        |
   |---+--------------+--------------------+--------------------|
   |   |     INTC     |        Open        | Pins 2 & 3 closed  |
   |---+--------------+--------------------+--------------------|
   |   |     INTD     |        Open        | Pins 1 & 2 closed  |
   +------------------------------------------------------------+