TEKRAM TECHNOLOGY CO., LTD. =========================== DC-690B +------------------------------------------------------------+ |------------------------------------------------------------| | Data bus: | 32-bit, PCI | |-------------------+----------------------------------------| | Size: | Three/quarter-length, full-height card | |-------------------+----------------------------------------| | Hard drive | Four IDE (AT) Interface drives | | supported: | | |-------------------+----------------------------------------| | Floppy drives | None | | supported: | | +------------------------------------------------------------+ +------------------------------------------------------------+ | CONNECTIONS | |------------------------------------------------------------| | Function | Location | |---------------------------------------------+--------------| | 40-pin IDE (AT) Interface connector - IDE-0 | CN1 | |---------------------------------------------+--------------| | 40-pin IDE (AT) Interface connector - IDE-1 | CN2 | |---------------------------------------------+--------------| | 14-pin PCI legacy-header connector | CN3 | |---------------------------------------------+--------------| | 10-pin cable connector to JP4 | CN4 | |---------------------------------------------+--------------| | 2-pin connector - drive active LED | JP1 | |---------------------------------------------+--------------| | 4-pin connector - cache error speaker | JP2 | |---------------------------------------------+--------------| | 10-pin cable connector to CN4 | JP4 | +------------------------------------------------------------+ +------------------------------------------------------------+ | PCI INTERRUPT SELECTION | |------------------------------------------------------------| | INT |JP3/jumper 1|JP3/jumper 2|JP3/jumper 3|JP3/jumper 4| |--------+------------+------------+------------+------------| |>>| INTA | closed | open | open | open | |-+------+------------+------------+------------+------------| | | INTB | open | closed | open | open | |-+------+------------+------------+------------+------------| | | INTC | open | open | closed | open | |-+------+------------+------------+------------+------------| | | INTD | open | open | open | closed | +------------------------------------------------------------+ +------------------------------------------------------------+ | USER CONFIGURABLE SETTINGS | |------------------------------------------------------------| | Function | Location | Setting | |-----------------------------------+--------------+---------| |>> | Hard drive port address 1F0h | JP3/jumper 5 | closed | | | and IRQ14 enabled | | | |---+-------------------------------+--------------+---------| | | Hard drive port address 170h | JP3/jumper 5 | open | | | and IRQ15 enabled | | | +------------------------------------------------------------+ +------------------------------------------------------------+ | DRIVE ACTIVE LED ERROR CODES (IMMEDIATELY AFTER POWER-UP) | |------------------------------------------------------------| | Status | Function | |----------------------------+-------------------------------| | One short flash | No cache DRAM installed | |----------------------------+-------------------------------| | Two short flashes | CPU error | |----------------------------+-------------------------------| | Three short flashes | SRAM error | |----------------------------+-------------------------------| | Four short flashes | Timer error | +------------------------------------------------------------+ +------------------------------------------------------------+ | MISCELLANEOUS TECHNICAL NOTES | |------------------------------------------------------------| | Some versions of this board have two 512KB x 8 DRAM chips | | mounted in place of Bank 0. In such a case the board will | | work without additional memory. In all other cases a pair | | of 256KB, 1MB, or 4MB SIMM modules must be installed in | | Bank 0 for the board to function. | | | | The optional ISA/EISA paddleboard solves the DC-690B | | incompatibility problem with some early PCI mainboards. If | | installed, connect CN3 to JP4, and set JP4/jumpers 1-4 in | | the open position. | +------------------------------------------------------------+