DATA TECHNOLOGY CORPORATION =========================== DTC5110 (REV. B) Card Type Floppy drive controller Chip Set DTC-403 Maximum Onboard N/A Memory I/O Options Floppy drive interface Hard Drives None supported Floppy drives Three 360KB, 720KB, 1.2MB, or 1.44MB supported drives Data Bus 8-bit ISA Card Size Half-length, full-height +------------------------------------------------------------+ | CONNECTIONS | |------------------------------------------------------------| | Function | Label | |-----------------------------------------------+------------| | 34-pin control cable connector - floppy drive | CN1 | +------------------------------------------------------------+ +------------------------------------------------------------+ | USER CONFIGURABLE SETTINGS | |------------------------------------------------------------| | Function | Label | Position | |-------------------------------------+-------+--------------| |>> | Primary port address 3F2h | W1 | Pins 1 & 2 | | | enabled | | closed | |---+---------------------------------+-------+--------------| | | Secondary port address 372h | W1 | Pins 2 & 3 | | | enabled | | closed | |---+---------------------------------+-------+--------------| |>> | Dual speed mode disabled | W3 | Open | |---+---------------------------------+-------+--------------| | | Dual speed mode enabled | W3 | Closed | |---+---------------------------------+-------+--------------| |>> | Standard logic for drive 0 | W4 | Pins 1 & 2 | | | enabled | | closed | |---+---------------------------------+-------+--------------| | | Reverse logic for drive 0 | W4 | Pins 2 & 3 | | | enabled | | closed | |---+---------------------------------+-------+--------------| |>> | Standard logic for drive 1 | W5 | Pins 1 & 2 | | | enabled | | closed | |---+---------------------------------+-------+--------------| | | Reverse logic for drive 1 | W5 | Pins 2 & 3 | | | enabled | | closed | |---+---------------------------------+-------+--------------| |>> | Standard logic for drive 2 | W6 | Pins 1 & 2 | | | enabled | | closed | |---+---------------------------------+-------+--------------| | | Reverse logic for drive 2 | W6 | Pins 2 & 3 | | | enabled | | closed | |---+---------------------------------+-------+--------------| |>> | Factory configured - do not | W7 | Unidentified | | | alter | | | |---+---------------------------------+-------+--------------| |>> | Factory configured - do not | W8 | Unidentified | | | alter | | | +------------------------------------------------------------+ +------------------------------------------------------------+ | WRITE PRECOMPENSATION SELECTION | |------------------------------------------------------------| | Write Precompensation | Data Rate | W2 | |----------------------------+------------------+------------| |>> | 125ns | N/A | Closed | |---------+------------------+------------------+------------| | | 125ns | 500Kbit/sec | Open | |---------+------------------+------------------+------------| | | 208ns | 300Kbit/sec | Open | |---------+------------------+------------------+------------| | | 250ns | 250Kbit/sec | Open | +------------------------------------------------------------+