DANPEX CORPORATION
==================

   EN/2

   NIC Type         Ethernet                                      
   Transfer Rate    10Mbps                                        
   Data Bus         16-bit MCA                                    
   Topology         Linear bus                                    
   Wiring Type      RG-58A/U 50ohm coaxial                        
                                                                  
                    AUI transceiver via DB-15 port                
   Boot ROM         Available                                     

<gopher://bitreich.org/I/th99/n/C-D/40470-1.png>
   

   +------------------------------------------------------------+
   |                         CABLE TYPE                         |
   |------------------------------------------------------------|
   |                Type                |      JP2B - JP2I      |
   |------------------------------------+-----------------------|
   |>> |     RG-58A/U 50ohm coaxial     |   Pins 1 & 2 closed   |
   |---+--------------------------------+-----------------------|
   |   | AUI transceiver via DB-15 port |   Pins 2 & 3 closed   |
   +------------------------------------------------------------+

   +------------------------------------------------------------+
   |                     ONBOARD TERMINATOR                     |
   |------------------------------------------------------------|
   |            Setting            |            JP3             |
   |-------------------------------+----------------------------|
   |>>         |     Disabled      |     Pins 1 & 2 closed      |
   |-----------+-------------------+----------------------------|
   |           |      Enabled      |     Pins 2 & 3 closed      |
   |------------------------------------------------------------|
   | Note:If the card is on either end of a linear bus network  |
   | segment, the onboard terminator may be used instead of an  |
   | external terminator                                        |
   +------------------------------------------------------------+

   +------------------------------------------------------------+
   |                FACTORY CONFIGURED SETTINGS                 |
   |------------------------------------------------------------|
   |           Jumper           |            Setting            |
   |----------------------------+-------------------------------|
   |            JP1             |            Unused             |
   |----------------------------+-------------------------------|
   |            JP2A            |       Pins 2 & 3 closed       |
   +------------------------------------------------------------+

   +------------------------------------------------------------+
   |                     DIAGNOSTIC LED(S)                      |
   |------------------------------------------------------------|
   |     LED     |    Status    |           Condition           |
   |-------------+--------------+-------------------------------|
   |    LED1     |      On      |   Data is being transmitted   |
   |-------------+--------------+-------------------------------|
   |    LED1     |     Off      | Data is not being transmitted |
   |-------------+--------------+-------------------------------|
   |    LED2     |      On      | Collision detected on network |
   |-------------+--------------+-------------------------------|
   |    LED2     |     Off      |       Normal operation        |
   |-------------+--------------+-------------------------------|
   |    LED3     |      On      |    Data is being received     |
   |-------------+--------------+-------------------------------|
   |    LED3     |     Off      |  Data is not being received   |
   +------------------------------------------------------------+