TEXT View Source
# ACCULOGIC, INC.
ISAPPORT
+------------------------------------------------------------+
|------------------------------------------------------------|
| Data bus: | 16-bit ISA |
|---------------+--------------------------------------------|
| Size: | Half-length, full-height card |
|---------------+--------------------------------------------|
| Hard drive | Up to seven Fast SCSI-2 devices |
| supported: | |
|---------------+--------------------------------------------|
| Floppy drives | Two 360KB, 720KB, 1.2MB, 1.44MB, or 2.88MB |
| supported: | drives |
+------------------------------------------------------------+
IMG IMG 1
+------------------------------------------------------------+
| CONNECTIONS |
|------------------------------------------------------------|
| Function | Location |
|------------------------------------------+-----------------|
| 50-pin SCSI connector - external | J1 |
|------------------------------------------+-----------------|
| 50-pin SCSI connector - internal | J2 |
|------------------------------------------+-----------------|
| 34-pin cable connector - floppy drive | J3 |
|------------------------------------------+-----------------|
| 4-pin power connector | J8 |
|------------------------------------------+-----------------|
| 4-pin connector - drive active LED | J9 |
+------------------------------------------------------------+
+------------------------------------------------------------+
| USER CONFIGURABLE SETTINGS |
|------------------------------------------------------------|
| Function | Location | Setting |
|--------------------------------+------------+--------------|
| » | Floppy drive interface | JP2 | Pins 2 & 3 |
| | enabled as primary | | closed |
|-----+--------------------------+------------+--------------|
| | Floppy drive interface | JP2 | Pins 1 & 2 |
| | disabled | | closed |
|-----+--------------------------+------------+--------------|
| » | Normally configure board | SW1 | Position 2 |
| | during installation | | |
|-----+--------------------------+------------+--------------|
| | Lock configuration | SW1 | Position 1 |
| | during installation | | |
|-----+--------------------------+------------+--------------|
| | Reset configuration | SW1 | Position 3 |
|------------------------------------------------------------|
| Note: SW1 is set to normal unless two ISApport boards are |
| installed on the same system. In this |
| |
| situation, the boards are installed sequentially. First, |
| board 1 is installed and configured. Then, |
| |
| its SW1 is set to lock, and board 2 is installed and |
| configured with its SW1 set to normal. |
| |
| The reset setting for SW1 is not identified. |
+------------------------------------------------------------+