TEXT View Source
# ADVANCED INTERLINK CORPORATION
AICEther-8/10BT (No Boot ROM)
NIC Type Ethernet
Transfer Rate 10Mbps
Data Bus 8-bit ISA
Topology Star
Wiring Type Unshielded twisted pair
Boot ROM Not available
IMG IMG 1
+------------------------------------------------------------+
| SEGMENT LENGTH |
|------------------------------------------------------------|
| Maximum Segment Length | JP1 |
|---------------------------------------+--------------------|
| 100 meters | Closed |
|---------------------------------------+--------------------|
| 300 meters | Open |
|------------------------------------------------------------|
| Note:Segment length is the distance from the card to the |
| hub. |
+------------------------------------------------------------+
+------------------------------------------------------------+
| I/O BASE ADDRESS |
|------------------------------------------------------------|
| Address | JP2D | JP2E |
|---------------------+-------------------+------------------|
| | 200h | Closed | Closed |
|---+-----------------+-------------------+------------------|
| | 210h | Closed | Open |
|---+-----------------+-------------------+------------------|
| » | 300h | Open | Closed |
|---+-----------------+-------------------+------------------|
| | 310h | Open | Open |
+------------------------------------------------------------+
+------------------------------------------------------------+
| INTERRUPT REQUEST |
|------------------------------------------------------------|
| IRQ | JP2F | JP2G | JP2H |
|--------------+---------------+--------------+--------------|
| | 2 | Closed | Open | Open |
|---+----------+---------------+--------------+--------------|
| » | 3 | Open | Closed | Open |
|---+----------+---------------+--------------+--------------|
| | 5 | Open | Open | Closed |
+------------------------------------------------------------+
+------------------------------------------------------------+
| RECEIVE WIRE POLARITY |
|------------------------------------------------------------|
| Mode | SW1 |
|------------------------------------------+-----------------|
| » | Normal | On |
|---------------+--------------------------+-----------------|
| | Inverted | Off |
|------------------------------------------------------------|
| Note:If the diagnostic LEDs indicate that the receive |
| wires' polarities are reversed (LED1 Off, Hub LED On) |
| you can |
+------------------------------------------------------------+
+------------------------------------------------------------+
| TX/RX CROSSOVER |
|------------------------------------------------------------|
| Mode | SW2 |
|-----------------------------------------+------------------|
| » | Normal | On |
|----------------+------------------------+------------------|
| | Crossover | Off |
|------------------------------------------------------------|
| Note:If the diagnostic LEDs indicate that the transmit & |
| receive wires are reversed (LED1 Off, Hub LED Off) you |
| can correct the problem by using the crossover option. |
+------------------------------------------------------------+
+------------------------------------------------------------+
| FACTORY CONFIGURED SETTINGS |
|------------------------------------------------------------|
| Jumper | Setting |
|------------------------------+-----------------------------|
| JP2A | Unused |
|------------------------------+-----------------------------|
| JP2B | Unused |
|------------------------------+-----------------------------|
| JP2C | Unused |
|------------------------------+-----------------------------|
| JP4 | Unused |
+------------------------------------------------------------+
+------------------------------------------------------------+
| DIAGNOSTIC LED(S) |
|------------------------------------------------------------|
| LED1 | Hub LED | Condition |
|---------+------------+-------------------------------------|
| On | On | Network connection is good |
|---------+------------+-------------------------------------|
| Off | Off | Transmit/Receive crossover at card |
|---------+------------+-------------------------------------|
| On | Off | Receive polarity reversed at hub |
|---------+------------+-------------------------------------|
| Off | On | Receive polarity reversed at card |
|------------------------------------------------------------|
| Note:The Hub LED is located on the hub, not on the card. |
+------------------------------------------------------------+