TEXT View Source
# JC INFORMATION SYSTEMS CORPORATION
ELS II (ASSY#1017-200-01)
NIC Type Ethernet
Transfer Rate 10Mbps
Data Bus 16-bit ISA
Topology Linear bus
Wiring Type RG58A/U 50ohm coaxial
AUI transceiver via DB-15 port
Boot ROM Available
IMG IMG 1
+------------------------------------------------------------+
| CABLE TYPE |
|------------------------------------------------------------|
| Type | JP1A - JP1F |
|------------------------------------+-----------------------|
| » | RG58A/U 50ohm coaxial | Closed |
|---+--------------------------------+-----------------------|
| | AUI transceiver via DB-15 port | Open |
+------------------------------------------------------------+
+------------------------------------------------------------+
| I/O BASE ADDRESS & BOOT ROM ADDRESS |
|------------------------------------------------------------|
| I/OAddress | Boot ROM Address | JP4A | JP4B |
|---------------+------------------+------------+------------|
| 300h | C8000h | Closed | Closed |
|---------------+------------------+------------+------------|
| 320h | CC000h | Open | Closed |
|---------------+------------------+------------+------------|
| 340h | D0000h | Closed | Open |
|---------------+------------------+------------+------------|
| 360h | D4000h | Open | Open |
+------------------------------------------------------------+
+------------------------------------------------------------+
| BOOT ROM |
|------------------------------------------------------------|
| Setting | JP4C |
|---------------------------------+--------------------------|
| » | Disabled | Open |
|---+-----------------------------+--------------------------|
| | Enabled | Closed |
+------------------------------------------------------------+
+------------------------------------------------------------+
| INTERRUPT REQUEST |
|------------------------------------------------------------|
| IRQ | JP5A | JP5B | JP5C | JP5D |
|------------+-----------+-----------+-----------+-----------|
| » | 2/9 | Closed | Open | Open | Open |
|---+--------+-----------+-----------+-----------+-----------|
| | 3 | Open | Closed | Open | Open |
|---+--------+-----------+-----------+-----------+-----------|
| | 4 | Open | Open | Closed | Open |
|---+--------+-----------+-----------+-----------+-----------|
| | 5 | Open | Open | Open | Closed |
+------------------------------------------------------------+
+------------------------------------------------------------+
| ONBOARD TERMINATOR |
|------------------------------------------------------------|
| Setting | JP6 |
|---------------------------------------+--------------------|
| » | Disabled | Open |
|--------------+------------------------+--------------------|
| | Enabled | Closed |
|------------------------------------------------------------|
| Note:If the card is on either end of the network segment |
| the onboard terminator can be used instead of using an |
| external terminator (JP6 closed). |
+------------------------------------------------------------+
+------------------------------------------------------------+
| COMPATIBILITY MODE |
|------------------------------------------------------------|
| Setting | W16 |
|----------------------------------------+-------------------|
| » | Disabled | Closed |
|--------------+-------------------------+-------------------|
| | Enabled | Open |
|------------------------------------------------------------|
| Note:If the system in which the card is to be installed |
| uses a C & T CS8220 chipset compatibility mode must be |
| enabled (W16 open). |
+------------------------------------------------------------+
+------------------------------------------------------------+
| FACTORY CONFIGURED SETTINGS |
|------------------------------------------------------------|
| Jumper | Setting |
|------------------------------+-----------------------------|
| JP2 | Unused |
+------------------------------------------------------------+
+------------------------------------------------------------+
| DIAGNOSTIC LED(S) |
|------------------------------------------------------------|
| Color | Status | Condition |
|-----------+------------+-----------------------------------|
| Green | On | Data is being transmitted or |
| | | received |
|-----------+------------+-----------------------------------|
| Green | Off | Data is not being transmitted or |
| | | received |
|-----------+------------+-----------------------------------|
| Red | Off | Network connection is good |
|-----------+------------+-----------------------------------|
| Red | On | Network connection is broken |
|------------------------------------------------------------|
| Note:The location of the diagnostic LEDs may vary on |
| different revisions of this card. |
+------------------------------------------------------------+