This is a program designed to speed up writing tapes on remote tape
drives.  Requirements are shared memory and locks which normally
means that these are supported in your kernel.

Buffer has been tested under SunOS 4.0.*, SunOS 4.1.*, Solarix, HP-UX 7.0,
and Gould UTX 2.1A (sv universe).

The program splits itself into two processes.  The first process reads
(and reblocks) from stdin into a shared memory buffer.  The second
writes from the shared memory buffer to stdout.  Doing it this way
means that the writing side effectly sits in a tight write loop and
doesn't have to wait for input.  Similarly for the input side.  It is
this waiting that slows down other reblocking processes, like dd.

I run an archive and need to write large chunks out to tape regularly
with an ethernet in the way.  Using 'buffer' in a command like:

	tar cvf - stuff | rsh somebox "buffer > /dev/rst8"

is a factor of 5 faster than the best alternative, gnu tar with its
remote tape option:

	tar cvf somebox:/dev/rst8 stuff

We have been using buffer here at Imperial for a couple of years now
for writing tar tapes and the main system dumps.

Thanks to Kevin Twidle <kpt@doc.ic.ac.uk> for the -p and -B code.

INSTALLATION:
	Check that your kernel supports shared memory and semaphores.
	A quick way to check is to build buffer and run it.
	If it says "couldn't create shared memory segment" you probably
	need to reconfigure and rebuild your kernel.

	To install edit the Makefile and tailor the variables to
	your local systems.  Then type make.

DISCLAIMER:
	This package is under the GNU GENERAL PUBLIC LICENSE!
	In addtion under NO circumstances can I, or Imperial College,
	be held liable for any event caused by the running or storing 
	of this program or its documentation.
	
Lee McLoughlin.                          Phone: +44 71 589 5111 X 5085
Dept of Computing, Imperial College,     Fax: +44 71 581 8024
180 Queens Gate, London, SW7 2BZ, UK.    Email: L.McLoughlin@doc.ic.ac.uk

.